Check Point 61000 Servisní příručka stáhnout pdf (Strana 18)

Required Tools

Step 2: Installing the Device in a Rack Page 18

Step 2: Installing the Device in a

Rack

Before mounting on rack

 Insert the:

 AC PSUs or DC PEMs

 Fan Units

 Attach the rear-end static grounding screws to the chassis.

To install the Chassis on the Rack:

1. Set the chassis in front of the rack, centering the chassis in front the shelf.

2. Lift and slide the chassis on to the rack shelf.

3. Make sure that the holes in the front mounting flanges of the chassis align with the holes in the rack

rails.

4. Insert mounting screws into the front mounting flanges aligned with the rack.

5. Secure the appliance by fastening the mounting screws to the rack

The appliance must be level, and not positioned at an angle.

6. Attach grounding cables to the grounding screws on the chassis.

Step 3: Installing Components and

Connecting Power Cables

This section covers inserting:

 One or more Chassis Management Modules

 One or more Security Switch Modules

 Security Gateway Modules

 Twisted pair and fiber optic transceivers into ports on the Security Switch Modules

 Transceivers into the management ports on the Security Switch Modules

 Covers for blank slots

This section also covers:

 Backup chassis in a dual chassis environment

 Power cables

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 46 47

Žádné komentáře

Check Point 61000 Servisní příručka Strana 18